NC-200 PB - Installation Manual - Page: 3
Warning:
Before starting up the DRO, carefully read the instructions of
Chapter 2 in the Installation Manual.
The DRO must not be powered-on until verifying that the
machine complies with the "89/392/CEE" Directive.
4.
Operation with the RS-232-C serial line ....................................... 49
4.1.
Saving and restoring data ...................................................................49
4.2
Parameter transmitting format .............................................................49
5
SETUP ............................................................................................ 50
5.1
Test mode .........................................................................................50
5.1.1
Direct access to the parameters ..........................................................53
5.2
Axis setting........................................................................................54
5.2.1
Open loop without analog voltage output. P46(3)=0, P46(5)=0 ............54
5.2.2
Open loop with analog voltage output. PAR46(3)=1, PAR46(5)=0 .......55
5.2.3
Closed loop. PAR 46(3)=1, PAR46(5)=1 ............................................55
Appendix ........................................................................................................ 57
Error codes ......................................................................................................57
Maintenance......................................................................................................58