Fagor Eco Concept CCO-120, Service Manual

Page: 36 / 79

02/05/2020 35
SERVICE MANUAL
CONVEYOR BELT
DISHWASHERS
19.8.2. DETERGENT DISPENSER
The detergent entry point to the wash tub is in the upper part of the front
of the tub and is identified by a label.
There is a covered hole just next to this, and a packing gland should be
installed here for the detergent dispenser
A stainless steel packing gland should be used, as detergent is an
abrasive product and plastic packing glands wear faster.
19.8.3.
RINSE AID DISPENSER
19.8.4.
FEEDERS´ ELECTRICAL CONNECTION
To complete the electrical connection of the detergent and rinse aid dispensers, remove the upper cover protecting the
electrical panel in order to access the connection strip for the dispensers/Limit switch DE .
First turn the mains switch IG to OFF in
order to remove the cover. Next, remove
the fastening bolts and undo the cover.
IG
The rinse aid / detergent dispenser connection cables must be inserted through the two packing glands DSR and
connected to the rinse aid /limit switch connection strip DE . The connection options are shown in Fig.13 .
The rinse aid inlet point should be mounted on the water inlet to the drum, as
shown in the diagram.
The yellow cap shown in the figure should be removed. This will provide an
inlet with 1/8
”
thread where the rinse aid dispenser pipe can be connected.
In ECO models with hot water gas generator, the rinse aid dispenser
connection should be on the hot water generator itself .