Fagor CO-500, Service Manual, Page: 36 / 124

22/07/2019
35
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
9.4.3. THERMO-STOP
The “Termostop” is a function which guarantees the water temperature during the rinse cycle.
•
If the “Termostop” is not active: Even if the wash time for the selected programme has ended, the
wash will not end until PC=0. Then, the appliance switches to the rinse cycle.
•
If the “Thermostop” is active: Even if the wash time for the selected programme has ended, the wash
will not end until PC=0 and (TC=0 or TC=1 after 8 minutes). Then, the appliance switches to the rinse
cycle.
•
The rinse time will depend on the configuration of the DIP4.
o If DIP4=0: Rinse time=14 sec.
o If DIP4=1: Rinse time=11 sec.
9.4.4. SOFT START
“Soft Start” is a function which controls the start-up of the pump so that the pump starts at a low speed which
increases gradually.
The wash pump has a “Soft Start” for a gentle start. The ramp for this “Soft Start” is defined below:
o
Time (s): 0 Voltage: 115
o
Time (s): 1 Voltage: 115
o
Time (s): 2 Voltage: 115
o
Time (s): 3 Voltage: 115
o
Time (s): 4 Voltage: 115
o
Time (s): 5 Voltage: 115
o
Time (s): 6 Voltage: 115
o
Time (s): 7 Voltage: 115
o
Time (s): 8 Voltage: 135
o
Time (s): 9 Voltage: 165
o
Time (s): 10 Voltage: 200
o
Time (s): 11 Voltage: 230
9.4.5. DIAGNOSTICS
Any faults arising in the machine are notified with impulse trains from the “ON/OFF” led. The trains are formed of X
0.5 second impulses ON and 2 seconds OFF, as shown in the diagram below.
Example of a 2 impulse train