Fagor CNC 8070, Programming Manual, Page: 418 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
402
CNC 8070
14.
CNC VARI
ABLES
PLC r
e
la
te
d
(S
OFT
V02.0
X
)
384
14.11 PLC related
These variables are evaluated when being executed.
They have generic names.
• Replace the letter "i" with a number keeping the brackets.
This variable may be used to consult only the symbols defined with the PDEF command in the PLC
program.
(V.)PLC.I[n] V.PLC.I[16]
(V.)PLC.signal V.PLC.auxend
STATUS
PRG PLC INT R W
(V.)PLC.STATUS PLC status
"0" = Stopped "1" = Running
R — R — —
RESOURCES
PRG PLC INT R W
(V.)PLC.I[i] Status of PLC input [i] R/W — R/W — —
(V.)PLC.O[i] Status of PLC output [i] R/W — R/W — —
(V.)PLC.M[i] Status of PLC mark [i] R/W — R/W — —
(V.)PLC.R[i] Status of PLC register [i] R/W — R/W — —
(V.)PLC.T[i] Status of PLC timer [i] R — R/W — —
(V.)PLC.C[i] Status of PLC counter [i] R — R/W — —
(V.)PLC.signal Status of exchange signals with CNC
(any mark or register)
R/W — R/W — —
SYMBOLS PRG PLC INT R W
(V.)PLC.symbol Status of the external symbols defined at the PLC R/W — R/W — —
MESSAGES
PRG PLC INT R W
(V.)PLC.MSG[i] Status of PLC message [n]
"0" = Inactive "1" = Active
R/W — R/W — —
(V.)PLC.PRIORMSG Active message with the highest priority (the one with
the lowest number among the active ones) R — R — —
(V.)PLC.EMERGMSG Active emerging message (the one shown at full
screen) R — R — —
ERRORS
PRG PLC INT R W
(V.)PLC.ERR[i] Status of PLC error [n]
"0" = Inactive "1" = Active
R/W — R/W — —
(V.)PLC.PRIORERR Active error with the highest priority (the one with the
lowest number among the active ones) R — R — —
TIMER
PRG PLC INT R W
(V.)PLC.TIMER Value of the timer enabled by PLC R/W R/W R/W Syn Syn
The PLC "TIMER" is enabled or disabled with the PLC mark TIMERON. It counts when TIMERON=1
Using the variable (V.)PLC.TIMER, it is possible to consult and/or modify its count. Value in seconds.