Fagor CNC 8070, Programming Manual, Page: 283 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
CNC 8070
CYCLE EDI
T
OR
Tappi
ng.
12.
(S
OFT
V02.0
X
)
249
12.5 Tapping.
Geometric parameters:
Type of tapping (icon).
Tapping with a clutch
(a)
.
Rigid tapping
(b)
.
Machining parameters:
Spindle turning direction (icon).
Clockwise with icon
(c)
and counterclockwise with icon
(d)
Type of feedrate (icon).
In mm/min or (inch/min)
(e)
.
In mm/vuelta
(f)
.
X, Y Machining point.
Z Part surface coordinate.
Zs Safety plane coordinate.
P Total depth.
Kf Feedrate factor for the exit.
Rigid tapping allows a rapid exit from the tap maintaining
always the synchronism between the feedrate and the speed.
The withdrawal feedrate is multiplied by this factor (Kf) and the
speed adapts to the new feedrate.
F Feedrate.
S Spindle speed.
T Tool.
D Tool offset.
t Dwell at the bottom, in seconds.
(b) (a)
(d) (c)
(f) (e)