Fagor CNC 8070, Programming Manual, Page: 254 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
232
CNC 8070
11.
MULTI
PLE MACHI
NI
NG
G
162.
M
u
lt
ip
le
m
a
chi
n
ing i
n
g
ri
d
pat
te
rn
(S
OFT
V02.0
X
)
220
11.3 G162. Multiple machining in grid pattern
The programming format for this cycle is:
When defining the length of the grid only two of parameters "X", "I" and
"K" are required.
G162 A B X I Y J P Q R S T U V
X K Y D
I K J D
A Angle, in degrees of the machining path with respect to the
abscissa axis.
If not programmed, a value of A = 0 is assumed.
B Angle between both machining paths.
If not programmed, a value of B = 90 is assumed.
X Length of the drid.
I Step between machining operations along the path.
K Total number of machining operations along the path,
including that of the machining definition point.
X I X K I K
When selecting the "X-I" format, bear in mind that the resulting number of
machining operations must be an integer, otherwise, the CNC will issue
the relevant error message.