Fagor CNC 8070, Programming Manual, Page: 247 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
CNC 8070
MULTI
PLE MACHI
NI
NG
G
160.
M
u
lt
ip
le
m
a
chi
n
ing
in
s
tr
a
ight
l
in
e
11.
(S
OFT
V02.0
X
)
213
11.1 G160. Multiple machining in straight line
The programming format for this cycle is:
When defining the machining operation, only two of parameters "X",
"I" and "K" are required.
G160 A X I P Q R S T U V
X K
I K
A Angle, in degrees of the machining path with respect to the
abscissa axis.
If not programmed, a value of A = 0 is assumed.
X Length of the machining path.
I Step between machining operations.
K Total number of machining operations in the section, including
that of the machining definition point.
X I X K I K
When selecting the "X-I" format, bear in mind that the resulting number of
machining operations must be an integer, otherwise, the CNC will issue
the relevant error message.