Fagor CNC 8070, Programming Manual, Page: 353 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
CNC 8070
CYCLE EDI
T
OR
S
lo
t m
illin
g
12.
(S
OFT
V02.0
X
)
319
4.1. Penetration "I" at feedrate "Fz".
4.2. Slot milling of the boss surface up to a distance "
δ
" from the
side wall. It is carried out at feedrate "F" and, if necessary,
it recalculates the pass (
∆
) so all the passes are identical.
4.3. Rapid withdrawal (G0) up to the safety plane (Zs).
4.4. Rapid movement (G0) to the starting point.
4.5. Rapid approach (G0) up to 1 mm off the machined surface.
5. Rapid withdrawal (G0) up to the safety plane (Zs).
6. It selects the finishing tool and it approaches in rapid (G0) down
to 1 mm from the roughed out bottom.
7. Finishing of the bottom of the slot.
7.1. Penetration at feedrate "Fz".
7.2. Milling of the bottom of the slot up to a distance "
δ
" from the
pocket wall. It is carried out at finishing feedrate "F" and, if
necessary, it recalculates the finishing pass (
∆
) so all the
passes are identical.
8. Rapid withdrawal (G0) up to the safety plane (Zs).
9. Finishing of the side walls.
It is carried out in "N" passes at the finishing feedrate "F".
10. Rapid withdrawal (G0) up to the safety plane (Zs).