Fagor CNC 8060, Operating Manual

Page: 42 / 172

Operating manual (MC).
CNC 8060
CNC 8065
2.
O
PERATING
IN JO
G MODE
Spindle control
·42·
(R
EF
: 1709)
2.3 Spindle control
Displaying the data of several spindles.
The screen only shows the data on one spindle. If there are several spindles in the channel,
the data on the next spindle may be displayed by pressing the "S" key. The first push is to
program the turning speed, the second one shows the data on the second spindle and so on.
Spindle control
The spindle may be controlled manually using the following keys of the operator panel. The
keys always refer to the master spindle of the active channel.
The spindle speed should be set (in the MDI mode) before selecting the turning direction,
thus avoiding a sudden start of the spindle when setting an "S" because the turning direction
was active.
Vary the speed override from the operator panel.
With the operator panel, it is possible to change the percentage of spindle speed using a
jog keyboard or a switch (depending on model).
Key. Meaning.
Start the spindle clockwise (same as M03 function) at the active speed. The CNC
shows the M03 function in the program history.
Start the spindle counterclockwise (same as M04 function) at the active speed. The
CNC shows the M04 function in the program history.
Stop the spindle (same as M05 function). The CNC shows the M05 function in the
program history.
Orient the spindle (same as M19 function). The CNC shows the M19 function in the
program history.
Key. Meaning.
Increases or decreases the percentage of spindle speed. The maximum and
minimum values as well as the incremental step are set by the OEM, the typical values
being a variation between 50% and 120% with a 5% step.
It sets the percentage of turning speed to be applied. The maximum and minimum
values are set by the OEM, the typical values being a variation between 50% and
120%.
_
+
200
190
180
170
160
150
140
130
120
110
100 90 80
70
60
50
40
30
20
10
4
2
0
SPEED