Fagor CNC 8055i, Installation Manual

Page: 727 / 732

Installation manual
CNC 8055
CNC 8055i
Q.
S
OFT
: V02.2
X
·727·
Mai
n
te
nan
ce
MAINTENANCE
Cleaning
The accumulated dirt inside the unit may act as a screen preventing the proper dissipation of the
heat generated by the internal circuitry which could result in a harmful overheating of the CNC and,
consequently, possible malfunctions.
On the other hand, accumulated dirt can sometimes act as an electrical conductor and short-circuit
the internal circuitry, especially under high humidity conditions.
To clean the operator panel and the monitor, a smooth cloth should be used which has been dipped
into de-ionized water and /or non abrasive dish-washer soap (liquid, never powder) or 75º alcohol.
Never use air compressed at high pressure to clean the unit because it could cause the accumulation
of electrostatic charges that could result in electrostatic shocks.
The plastics used on the front panel are resistant to :
• Grease and mineral oils.
• Bases and bleach.
• Dissolved detergents.
• Alcohol.
Fagor Automation shall not be held responsible for any material or physical damage derived from the
violation of these basic safety requirements.
To check the fuses, first unplug the unit from mains If the CNC does not turn on when flipping the power
switch, check that the fuses are the right ones and they are in good condition.
Avoid solvents. The action of solvents such as chlorine hydrocarbons, benzole, esters and ether may
damage the plastics used to make the front panel of the unit.
Do not manipulate the inside of the unit. Only personnel authorized by Fagor Automation may access
the interior of this unit.
Do not handle the connectors with the unit connected to AC power. Before handling these connectors
(I/O, feedback, etc.), make sure that the unit is not connected to main AC power.