Fagor 8025 M CNC, Translation Of The Original Manual

Page: 165 / 180

Remote modules.
CNC 8060
CNC 8065
CAN BUS (CANFAGOR/CANOPEN
PR
OTOCOLS).
8.
·165·
(R
EF
: 1906)
8 CAN BUS (CANFAGOR/CANOPEN PROTOCOLS).
CANfagor and CANopen are two network communication protocols based on the CAN bus
system for connecting the CNC with remote modules and keyboards. The CAN connection
supports up to 32 devices (nodes), including the central unit; more one than keyboard and
several groups of remote modules are possible.
CAN connector.
5-pin male Phoenix minicombicon contact (3.5 mm pitch).
The cable shield must be connected to the connector at both ends. The connector has two
shield pins. Both pins are equivalent and the CAN shield may be connected to either one.
CAN cable characteristics.
Use a specific CAN cable. The ends of all the wires and the shield must be protected by the
corresponding terminal (pin). Also use the terminals (pins) to secure the cable to the
connector.
General characteristics.
Type. Shielded. Twisted pair (1 x 2 x 0.22 mm²).
Flexibility. Extremely flexible. Minimum bending radius, static = 50 mm and
dynamic = 95 mm.
Cover. PUR
Impedance. Cat.5 (100

- 120

)
CNC
GROUP
1
GROUP
2
GROUP
3
GROUP
n
Pin. Signal. Function.
1 ISO GND Ground / 0 V.
2 CAN L (LOW) bus signal.
3 SHIELD CAN shield.
4 CAN H (HIGH) bus signal.
5 SHIELD CAN shield.
1 2 3 4 5
ISO
G
N
D
CA
N L
SH
IE
LD
CA
N H
SH
IE
LD