FabWeaver A530, User Manual

Page: 16 / 120

Before using the Machine
8
5. How to Handle Consumables
The filament provided by fabWeaver can absorb moisture when exposed to moisture like other thermoplastic
materials, which can affect the surface or quality of the printout. In order to maintain proper product performance,
please store the filament according to the recommended procedure below.
- If the sealed filament is opened, do not leave it in the air for more than 5 minutes.
- When using filament for printing, put it together with the desiccant in the filament box and close
the lid immediately before use.
- When storing the filament after taking it out of the filament box, keep it sealed in the aluminum foil bag together
with the desiccant.
Note
- To maintain the dehumidifying performance of the desiccant, keep it sealed in an airtight container such as
a filament box or aluminum foil bag. If the desiccant is left in outside air, it may become saturated with moisture
and lose its ability to dehumidify.
If the filament and desiccant are exposed to moisture, you can use the printer’s chamber preheat function to restore
performance.
- After setting the chamber preheat temperature according to the type of filament, put the filament in the chamber
to dry it. (ABS/ASA/RSA - over 12 hours at 60°C, PLA – 4-5 hours at 40°C)
- After recovering the filament (desiccant) by using the chamber preheat function, immediately seal it and store it.
If not sealed immediately, contact with ambient air may degrade performance again.
Warning
- Do NOT burn filaments. It may ignite and cause a major fire or serious burn.
Caution
- Keep this product out of reach of children.
- If you have skin irritation after touching the filament, go to the doctor.
Important
- Do NOT store filaments in the following places:
Places exposed to flames
Places exposed to direct sunlight
Places where temperature or humidity may increase
Places where sudden temperature change may occur
Dusty places
Inside a vehicle for a long time
- Be careful NOT to apply physical impact or vibration to filaments.
- Do NOT unpack a filament until it is ready to be used.