REV0816
A
SSEMBLY
I
NSTRUCTIONS
5000
S
ERIES
D
RAPERY
T
RACK
Pinch Pleated Draperies Configured as a Panel
Cut track to length and attach end stops (use End Stops in pairs: one with a pull-out, and one without).
Secure track to ceiling or wall (see installation instructions). Once track is securely mounted, remove pull-
out from end stop, insert the required number of carriers (all standard carriers and one master carrier), and
reinsert pull-out into the end stop. To install the drapery, carefully slide the pin hooks, located at the top of
the drapery, through the loops on each of the carriers. To make the drapery a true one-way treatment,
secure the last carrier (the carrier farthest away from the master carrier) in place with a screw.
For smoother operation, lightly spray the inside of the track with an aerosol silicone lubricant. Depending
upon environment, clean and re-lubricate as necessary.
Note! For heavy-duty cord draw drapery configuration, the end stops can be replaced with End Pulleys
(part #5000-21) and heavy-duty nylon cord added. The routing of the cord and subsequent proper
operation is a fairly complex procedure that requires professional assembly.
Pinch Pleated Draperies Configured as a Pair
Cut track to length and attach end stops (use End Stops in pairs: one with a pull-out, and one without).
Secure track to ceiling or wall (see installation instructions). Once track is securely mounted, remove pull-
out from end stop, insert the required number of carriers (half of the standard carriers, both master carriers,
and the remaining standard carriers), and reinsert pull-out into the end stop. To install the drapery, carefully
slide the pin hooks, located at the top of the drapery, through the loops on each of the carriers. Each panel
of the drapery will begin at the outer edge and end at the center with a master carrier. The master carrier
with the offset arm will allow the paired drapery to overlap in the middle, creating a gap-free center closure.
Secure each of the outside end carriers in place with a screw.
For smoother operation, lightly spray the inside of the track with an aerosol silicone lubricant. Depending
upon environment, clean and re-lubricate as necessary.
Note! For heavy-duty cord draw drapery configuration, the end stops can be replaced with End Pulleys
(part #5000-21) and heavy-duty nylon cord added. The routing of the cord and subsequent proper
operation is a fairly complex procedure that requires professional assembly.