FabiaTech Corporation
Chapter 3 BIOS Setup
tup
This chapter describes the BIOS setup.
This chapter describes the BIOS setup.
Overview
Overview
BIOS are a program located on a Flash memory chip on a circuit board. It is used
to initialize and set up the I/O peripherals and interface cards of the system, which
includes time, date, hard disk drive, the ISA bus and connected devices such as
the video display, diskette drive, and the keyboard. This program will not be lost
when you turn off the system.
BIOS are a program located on a Flash memory chip on a circuit board. It is used
to initialize and set up the I/O peripherals and interface cards of the system, which
includes time, date, hard disk drive, the ISA bus and connected devices such as
the video display, diskette drive, and the keyboard. This program will not be lost
when you turn off the system.
The BIOS provides a menu-driven interface to the console subsystem. The console
subsystem contains special software, called firmware that interacts directly with the
hardware components and facilitates interaction between the system hardware
and the operating system.
The BIOS provides a menu-driven interface to the console subsystem. The console
subsystem contains special software, called firmware that interacts directly with the
hardware components and facilitates interaction between the system hardware
and the operating system.
The BIOS default values ensure that the system will function at its normal capability.
In the worst situation the user may have corrupted the original settings set by the
manufacturer.
The BIOS default values ensure that the system will function at its normal capability.
In the worst situation the user may have corrupted the original settings set by the
manufacturer.
All the changes you make will be saved in the system RAM and will not be lost after
power-off.
All the changes you make will be saved in the system RAM and will not be lost after
power-off.
When you start the system, the BIOS will perform a self-diagnostics test called Power
On Self Test (POST) for all the attached devices, accessories, and the system. Press
the [Del] key to enter the BIOS Setup program, and then the main menu will show
on the screen.
When you start the system, the BIOS will perform a self-diagnostics test called Power
On Self Test (POST) for all the attached devices, accessories, and the system. Press
the [Del] key to enter the BIOS Setup program, and then the main menu will show
on the screen.
Note: Change the parameters when you fully understand their functions and
subsequence.
Note: Change the parameters when you fully understand their functions and
subsequence.
17
