FabiaTech Corporation
CMOS CHECKSUM ERROR
This error informs that the CMOS has corrupted. When the battery runs weak, this
situation might happen. Please check the battery and change a new one when
necessary.
DISK BOOT FAILURE
When you can‘t find the boot device, insert a system disk into Drive A and press <
Enter >. Make sure both the controller and cables are all in proper positions, and
also make sure the disk is formatted. Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR
When the diskette drive type is different from CMOS, please run setup or configure
the drive again.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
When you can‘t initializes the hard drive, ensure the following things:
1.
The adapter is installed correctly
2.
All cables are correctly and firmly attached
3.
The correct hard drive type is selected in BIOS Setup
ERROR INITIALIZING HARD DISK CONTROLLER
When this error occurs, ensure the following things:
1.
The cord is exactly installed in the bus.
2.
The correct hard drive type is selected in BIOS Setup
3.
Whether all of the jumpers are set correctly in the hard drive
FLOPPY DISK CONTROLLER ERROR OR NO CONTROLLER PRESENT
When you cannot find or initialize the floppy drive controller, please ensure the
controller is in proper BIOS Setup. If there is no floppy drive installed, ensure the
Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
When this situation happens, please check keyboard attachment and no keys
being pressed during the boot. If you are purposely configuring the system without
a keyboard, set the error halt condition in BIOS Setup to HALT ON ALL, BUT
KEYBOARD. This will cause the BIOS to ignore the missing keyboard and continue
the boot procedure.
46
