3
Recommendations
and suggestions
• The Instructions for Use apply
to several versions of this appli-
DQFH$FFRUGLQJO\\RXPD\¿QG
descriptions of individual features
WKDWGRQRWDSSO\WR\RXUVSHFL¿F
appliance.
• The manufacturer will not be
held liable for any damages re-
sulting from incorrect or improper
installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• Check that the mains voltage
corresponds to that indicated on
WKHUDWLQJSODWH¿[HGWRWKHLQVLGH
of the hood.
• For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
H[KDXVW ÀXH WKURXJK D SLSH RI
minimum diameter 120 mm. The
URXWHRIWKHÀXHPXVWEHDVVKRUW
as possible.
• Do not connect the extractor
hood to exhaust ducts carrying
FRPEXVWLRQ IXPHV ERLOHUV ¿UH
-
places, etc.).
• If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances), a
VXI¿FLHQWGHJUHHRIDHUDWLRQPXVW
be guaranteed in the room in
RUGHUWRSUHYHQWWKHEDFNÀRZRI
exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
• In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
• If the instructions for installation
for the gas hob specify a greater
GLVWDQFHVSHFL¿HGDERYHWKLVKDV
to be taken into account. Regu-
lations concerning the discharge
RIDLUKDYHWREHIXO¿OOHG
• Use only screws and small parts
in support of the hood.
Warning:
Failure to install the
VFUHZV RU ¿[LQJ GHYLFH LQ DF
-
cordance with these instructions
may result in electrical hazards.
• Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
• The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has been
designed.
•
1HYHU OHDYH KLJK QDNHG ÀDPHV
under the hood when it is in
operation.
EN
