Faber PB10, Manual

Page: 1 / 2

70 Installation and User manual:
Model
Installation and User
’s manual PB - GB
Subject to technical changes
Installation TopFix / RecessFix [R1]
Do not damage the product when using a sharp knife to open
the packaging! Fitting screws: Use a size-2 screwdriver (PO-
ZIDRIVE) or use an electric screwdriver at it’s lowest torque .
Rail removal: Use a flat screwdriver of max. 6 mm wide. Only
use the original screws enclosed, to prevent malfunctioning
from using too thick screw heads!
X=5 cm
x x y
x x y
max. 35 cm
max. 35 cm
A
B
B 1 B 2
A
B
C
Removal
4 Bediening
B
C
A
1
1
Clip installation (toprail)
2
Clip installation (bottom rail)
3
Installation sequence
4
Tensioning/slackening the steel wire
5
Operation
3-A1 3-A2
3-B1 3-B2
Rail installation sequence on Clips
Note: if necessary, before clicking the rail
into place, slacken the steel wire. After
clicking, place cover on the bottom clips.
Push firmly to the right/left to tension/slacken
the steel wire
3 3 1 0 - 80 cm
4 4 1 81 - 115 cm
5 5 1 116 - 150 cm
6
8
10
Product width Number of parts
[R1]
21-03-2014
PB10
PB15