Faber Mertik, User Manual

Page: 9 / 12

User manual Symax
8 < < < <
Manual ignition (by the installer)
This action is intended for service purposes only!
To do this the following procedure should be
followed:

Remove the ignition lead from the
receiver (fig. 1.3-F) and place this on the
gas valve (fig. 1.5-C).

Turn the knob “B” clockwise with the
arrow to the OFF position (fig. 1.5).

Turn the dial “A” clockwise with the arrow
in the MAN position (fig. 1.5). Now the
pilot light valve “C” and the piezo-ignition
E are accessible.

Press the pilot flame valve “D” with a
screwdriver and keep the valve pressed.
Simultaneously press the piezo ignition
“E” several times. The pilot flame will now
ignite. If the pilot flame is burning, wait
approximately 20 sec. before releasing the
pilot valve.

Now turn the dial “A” anticlockwise with
the arrow to the ON position. (fig. 1.6).

Now the flame height can be adjusted by
turning the knob “B” anticlockwise past
the ON position (fig. 1.6) This causes a
rattling sound!

Please note!
When step burner, you can't switch between
narrow and wide manually!
Fault codes remote control
Fault code Duration time
fault code on
display Symptom Possible cause
F04 4 sec. - No pilot flame within 30 sec.
(Attention! After 3 failed
ignition attempts, error code
F06 appears). - No gas supply.
- Air in burner pipe pilot flame.
- No spark.
- Reversed polarity in thermocouple
wiring.
F06 4 sec. - 3 failed ignition attempts within
5 min.
- Fire doesn’t respond, no pilot
flame.
- No gas supply.
- Air in burner pipe pilot flame.
- No spark.
- Reversed polarity in thermocouple
wiring.
F09 4 sec. - No electronic control of fire. - The remote control isn’t paired with
receiver (see section 4.3).
Battery
symbol (F40) Permanent - Low battery voltage in remote
control - Replace batteries in remote control
(see section 3.2).
F46 4 sec. - Fire doesn’t respond.
- Intermittent response.
- No electronic control of fire.
- No or bad connection between
remote control and receiver. (see
section 4.3).
- Low battery receiver (see section 3.2).
- Power supply (6V adapter) is broken.
TVH