Faber 5x20 5A Installation Instructions Manual Download Page 1

Version 01/05 - Page 1

MAGNUM

Under Cabinet Rangehood

• Installation Instructions

• Use and Care Information

READ  AND  SAVE  THESE  INSTRUCTIONS

The Installer must leave these instructions with the homeowner.  

The homeowner must keep these instructions for future reference 

and for local electrical inspectors' use

.

READ  THESE  INSTRUCTIONS  BEFORE  YOU  START  INSTALLING  THIS  RANGEHOOD

WARNING: - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:  a) Never leave surface units unattended at high 

settings. Boilovers cause smoking and greasy spillovers that may ignite.  Heat oils slowly on low or medium setting.  b) 

Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Pepper

-

corn Beef Flambé).  c) Clean ventilating fans frequently.  Grease should not be allowed to accumulate on fan or filter.  d) 

Use proper pan size.  Always use cookware appropriate for the size of the surface element.

WARNING: - TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE 

THE FOLLOWING:  SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner.  BE 

CAREFUL TO PREVENT BURNS.  If the flames do not go out immediately EVACUATE AND CALL THE FIRE DEPARTMENT.  

NEVER PICK UP A FLAMING PAN - You may be burned.  DO NOT USE WATER, including wet dishcloths or towels - a 

violent steam explosion will result.  Use an extinguisher ONLY if: 1. You know you have a Class ABC extinguisher, and you 

already know how to operate it.  2. The fire is small and contained in the area where it started.  3. The fire department is 

being called.  4.  You can fight the fire with your back to an exit.

ALL  WALL  AND  FLOOR  OPENINGS  WHERE  THE  RANGEHOOD  IS  INSTALLED  MUST  BE  SEALED.

This rangehood requires at least 24" of clearance between the bottom of the rangehood and the cooking surface or countertop.  

This minimum clearance may be higher depending on local building code.  For example, for gas ranges, a minimum of 30" may 

be required.  The maximum depth of overhead cabinets is 13".   Overhead cabinets on both sides of this unit must be a minimum 

of 18" above the cooking surface or countertop.  Consult the cooktop or range installation instructions given by the manufacturer 

before making any cutouts.  MOBILE  HOME  INSTALLATION  The installation of this rangehood must conform to the Manufactured 

Home Construction and Safety Standards, Title 24 CFR, Part 3280 (formerly Federal Standard for Mobile Home Construction and 

Safety, Title 24, HUD, Part 280).  Four wire power supply must be used and the appliance wiring must be revised.  See Electrical 

Requirements.

LISEZ  BIEN  CETTE  FICHE  AVANT  D'INSTALLER  LA  HOTTE

AVERTISSEMENT - POUR MINIMISER LE RISQUE D’UN FEU DE GRAISSE SUR LA TABLE DE CUISSON : a) Ne jamais laisser 

un élément de la table de cuisson fonctionner sans surveillance à la puissance de chauffage maximale; un renversement/

débordement de matière graisseuse pourrait provoquer une inflammation et le génération de fumée. Utiliser toujours une 

puissance de chauffage moyenne ou basse pour le chauffage d’huile. b) Veiller à toujours faire fonctionner le ventilateur 

de la hotte lors d’une cuisson avec une puissance de chauffage élevée ou lors de la cuisson d’un mets à flamber (i.e. 

Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé).  c) Nettoyer fréquemment les ventilateurs d’extraction. Veiller 

à ne pas laisser de la graisse s’accumuler sur les surfaces du ventilateur ou des filtres. d) Utiliser toujours un ustensile 

de taille appropriée. Utiliser toujours un ustensile de taille adapté à la taille de l’élément chauffant.

AVERTISSEMENT: - POUR PRÉVENIR LES BLESSURES EN CAS DE FEU SUIVRE LES RECOMMANDATIONS SUIVANTES:  

ÉTOUFFEZ LE FEU avec un couvercle métallique et fermez le brûleur.  Si le feu ne s'éteint pas tout de suite, QUITTEZ LES 

LIEUX ET APPELEZ LES POMPIERS.  NE TOUCHEZ JAMAIS UNE CASSEROLE EN FLAMMES.  N'UTILISEZ JAMAIS DE 

L'EAU ou un torchon mouillé pour éteindre le feu - ce qui pourrait causer une explosion de vapeur.  N'utilisez un extincteur 

que si: 1.  Vous avez un modèle ABC et vous connaissez bien son mode d'emploi.  2.  Le feu est petit et peu répandu.  3.  

Les pompiers sont déjà prévenus.  4.  Vous avez une sortie derrière vous.

TOUTE  OUVERTURE  DANS  LE  MUR  OU  LE  PLANCHER  À  PROXIMITÉ  DE  LA  HOTTE  DOIT ÊTRE SCELLÉ

Gardez 24 po. de hauteur entre le bas de la hotte et la surface de cuisson. Cette hauteur minimum peut être plus haute suivant le 

code municipal.  Par exemple, les cuisinières à gaz peuvent requérir 30 po. de hauteur.  Les armoires au-dessus ne dépasseront 

pas 13 po. de profondeur.  Les armoires au-dessus de chaque côté devront être au moins à 18 po. au-dessus de la surface 

de cuisson.  Consultez la fiche technique avant de découper les armoires.  L'installation de cette hotte doit être conforme aux 

Réglements de Manufactured Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal 

Standard for Mobile Home Construction and Safety Standards, titre 24 CFR, Section 3280 (anciennement Federal Standard for 

Mobile Home Construction and Safety, titre 24, HUD, Section 280).  Le branchement électrique se fait avec une raccordement à 

4 fils.  Consultez la fiche technique électrique.

Summary of Contents for 5x20 5A













Reviews: