Faber 110.0456.294, Instruction Manual

Page: 22 / 40

EN
21
ELECTRICAL CONNECTION
• The mains voltage must match that given on the ratings label
inside the hood itself. If the hood has a power plug, connect the
hood to an easily accessible regulatory power socket. If it does
not (direct connection to the mains), or the socket is not easily
accessible, install a two-pole regulatory switch to enable total
disconnection from the mains in case of category III overvoltage,
as required by the installation regulations.
Tubes Assembly
Plug a set of pipes up to overlap to the engine
Upper Tube
•
Secure the sides to the brackets by using the 2 screws supplied
2x (Ø4x6)
Lower Tube
• It may be fixed, using the slots at the base of the lower
tube. In them, insert the cage nut 4x ( ) [see
A
].
Then, after removing filters, tighten the screws 4x (M4x10)
from the bottom of the hood.
LED Replacement

For replacement contact technical support.
!
A
A
•