FAAC 550 ITT, Instructions For Use Manual

Page: 8 / 12

ENGLISH
12
BASIC PROGRAMMING
Display
Function
Default
FUNCTION LOGICS:
= Automatic
= Semi-automatic
CLOSING SLOW START:
Settable from to sec.
PAUSE TIME:
This operates only if the automatic logic was selected. Can be adjusted from to sec.
in one second steps.
Next, the viewing changes in minutes and tenths of a second (separated by a dot) and time
is adjusted in 10 second steps, up to the maximum value of minutes.
E.g.: if the display shows , the pause time will be 2 min and 50 sec.
ELECTRONIC CLUTCH:
Limits the operator's maximum thrust.
Settable from (minimum force)
to (maximum force)
To exit programming and return to display of inputs status
ADVANCED PROGRAMMING
Display
Function
Default
COURTESY LIGHT:
For setting lighted time of the courtesy light.
Can be adjusted from to sec. in one second steps.
Next, the viewing changes in minutes and tenths of a second (separated by a dot) and time
is adjusted in 10 second steps, up to the maximum value of minutes.
E.g.: if the display shows , the lighted time will be 2 min and 50 sec.
MAXIMUM STARTING TORQUE:
= Active = Disabled
FAIL SAFE (safety devices operational check):
= Active = Disabled
7. PROGRAMMING
To program the operation of the automated system, you must access the "PROGRAMMING" mode.
Programming is in two parts: BASIC and ADVANCED.
7.1. BASIC PROGRAMMING
To access BASIC PROGRAMMING, use push-button F :
• if you press it (and hold it down), the display shows the name of the first function.
• if you release the push-button, the display shows the value of the function, which can be changed with keys
+ and - .
• if you press F again (and hold it down), the display shows the name of the next function, etc.
• when you reach the last function, press the F push-button to exit programming, and the display resumes showing the
inputs status.
The following table indicates the sequence of functions accessible in BASIC PROGRAMMING:
7.2. ADVANCED PROGRAMMING
To access ADVANCED PROGRAMMING, press push-button F and, while holding it down, press push-button + :
• if you release the + push-button, the display shows the name of the first function.
• if you also release the F push-button, the display shows the value of the function, which can be changed with keys + and - .
• if you press the F push-button (and hold it down), the display shows the name of the next function; if you release it, the
value is shown and can be changed with keys + and - .
• when you reach the last function, press the F push-button to exit programming, and the display resumes showing the
inputs status.
The following table indicates the sequence of functions accessible in ADVANCED PROGRAMMING: