F-SECURE POLICY MANAGER 7.0 -, Administrator'S Manual

Page: 61 / 241

61
4.1 Introduction
In F-Secure Policy Managerrelease 6.0 and onwards the use of
communication directory (CommDir) instead of F-Secure Policy Manager
Server is not supported. Therefore you must upgrade the CommDir based
installations to F-Secure Policy Manager Server installations.
This chapter contains instructions on how to do the migration, from
backing up the existing system to checking that all the managed hosts in
the network have started to communicate with F-Secure Policy Manager
Server.
4.2 Instructions
You can do the migration as follows:
Step 1. Back Up the Existing System
1. Before you start the back-up procedure, make sure that F-Secure
Policy Manager Console is not running.
2. Backup the management keys ( admin.pub and admin.prv ), and the
existing CommDir. By default, the management keys are located in
C:\Program Files\F-Secure\Administrator\
Step 2. Install New F-Secure Policy Manager Server and
Console
1. Install new F-Secure Policy Manager Server and Console. For
instructions, see “
Installing F-Secure Policy Manager Server ” , 29 and
“ Installing F-Secure Policy Manager Console ” , 64 .
2. During the F-Secure Policy Manager Server installation, copy the
existing CommDir Data from the backup you made in Step 1 above.
When the dialog (see the figure below) is displayed, click
Browse.. to
locate the backup.