F-One Stand Up Paddle, User Manual

Page: 17 / 24

When your SUP is exposed to high temperatures or
rapid temperature changes, the dilation of the air inside
could damage the board in an irreversible manner. This
is why your SUP is equipped with a decompression
screw. Your SUP is equipped with the F-ONE SMART
HANDLE with the decompression screw built in.
MAKE SURE YOU ALWAYS
∙ Fully screw the decompression screw when the
SUP is in contact with water.
∙ Unscrew the decompression screw while trave-
ling or storing your SUP.
The storage compartment of the multifunction tool has two positions. When the screw is slightly loosened
(open position), the tool can fit into the 1st slot of it’s compartment, but sticks out obstructing the handle
access. The user, regardless of who he is, will notice right away that the screw is not fully tighten, when he
lifts the board by the handle.
When the screw is fully tightened (closed position) the head of the screw is at the same level as
the compartment of the multifunction tool. The space is free to clip the tool all the way to the 2
nd
slot. The user can lift the board by the handle without any obstruction and bring the SUP in contact
with water.
The screw can be tightened or loosened with the multifunction tool that is equally built into the handle. A
rubber joint guarantees the seal will be water tight when the screw is fully tighten. When you loosen the
screw, just a few turns will suffice to allow air to flow through; there is no need to remove the screw.
Installing the decompression screw
FRANÇAIS
ENGLISH
17