B
INTRODUCTION
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
25
Owner’s Guide
To reinstall the controller splash shield, position the splash shield by aligning the mounting holes with the
holes in the body, push the center pin of each rivet upward so that the top of the pin is above the rivet head.
Place a rivet in each mounting hole of the controller splash shield and push down on the center pin until the
top of the pin is flush with the rivet head.
Front Seat
The front seat (9) is for two people, one person on each side of the seat (Figure 6).
Front Hip Restraint
Cup Holder
The vehicle has a cup holder (11) for the benefit of both the driver and passenger (Figure 6).
Steering Wheel
The steering wheel (12) controls the direction of vehicle travel (Figure 6).
Rear Seat and Cargo Platform (if equipped)
Rear passengers must stay in the seat and hold both the hand rail and rear handle while the
vehicle is in motion.
Do not allow passengers to ride on the cargo platform. A sudden move or stop can cause severe
injury or death to passengers on the cargo platform.
The vehicle has a feature that functions as a rear seat or a cargo platform.
When in the upright position, it is a rear seat for two passengers. Fold the seat flat for a cargo platform (13).
Rear Hand Rail
There are rear hand rail (14), one on each side of the rear seat to help passengers stay in position when the vehicle is in
motion. The passengers must hold the rear hand rail (14) whenever the vehicle is in motion (Figure 6).
Rear Handle
The rear handle (15) is located at the far end of the vehicle in the center of the footrest. The handle helps the passengers
stay in position when the vehicle is in motion. The passengers must hold the rear handle (15) when the vehicle is in
motion (Figure 6).
