12
1.4 Dual Source Copy + Compare
Two source devices with identical content will be used for this task. One source device is
inserted into source port while the other inserted into the 1
st
target port. Duplicator starts
copy process first and reads data content from the source port; duplicator then starts
compare process after copy is done, and reads data content from the 1
st
target port. By
comparing the copied devices against the second source, it can find out if the source device
has unexpected damage or not, and avoid the waste of time and media for further
duplication. The rest of procedure is the same as regular Copy + Compare procedure.
2. Quality
Check
In case of the damage to the original source media, Quality Check function will not be
executed on the source port.
2.1 H3 Test
Testing Read function under designated area in the flash media to verify if it is normal. It will
not change the original data stored in the flash media. Attention: this function only tests
Read function, but not Write function.
Use ▲or▼ to select the information of each port
Compare with the source on
the 1
st
target port
ENT
Copy from the source on
the source port
01:20 15%
[Duplicate]
4. Dual Source Copy+commpare
D_Copy:7 1100M
01:50 10%
Put source devices into Source
port and 1
st
target port
Result: 40 : 25
Pass
：
7 Fail
：
0
Final result
ENT
[#1]0 K 738M
R 10.9M W 0.0M
Result: 00:46
Pass
：
7 Fail
：
0
[Quality Check]
1. H3 Test
H3_TEST
：
1
00:20 (03) 10%
[#1]0 K: [#Port] failed capacity
738M: Capacity tested
R xxM/W xxM:
Read & Write speed
