- 6 -
2.
ASSEMBLING THE RISER
2.1. Lay the right hand stair side rails flat with tread channel cleats pointing up and insert the treads
into the channel cleats. Place on cardboard or other suitable surface to avoid scratching the side
rail. Make sure the tread is positioned with the traction ridges oriented upward. Use a rubber mallet
if needed to tap the tread into the tread channel cleat until the holes in the cleat line up with the
holes in the stair tread (FIG.1).
FIG. 1
2.2. Install
5/16”
-18 x 2-
1/4”
carriage bolts in the holes through the top side of the right hand channel
cleats. Use a rubber mallet to sink carriage bolts into holes. Install
5/16”
washers and nuts onto the
carriage bolts on the bottom side of the channel cleats but do not tighten fully yet (FIG. 2).
FIG. 2
Summary of Contents for Pathway Stair System
Page 12: ...12 FIG 12 FIG 13...