- 13 -
4.
INSTALLING THE CONNECTOR
–
HR PLATFORM TO HR STAIR (MHRPSC)
(OPTIONAL EQUIPMENT)
4.1. Installation of the closure elbows in the CONNECTOR
–
HR PLATFORM TO HR STAIR
(MHRPSC), used to connect a stair top post to a platform handrail post, is similar to installing the
stair handrails but the closure elbow is not disassembled first. Assemble one closure elbow to the
stair top post and one to the platform handrail post opposite the stair top post using the provided
5/16”
-
18 x 3/4” long hex bolts but do not tighten fully
(FIG. 14).
FIG. 14
4.2. The closure elbow attached to the stair top post should be at approximately 90 degrees and
pointed toward the closure elbow attached to the platform handrail post. Align the round portions of
the closure elbows facing each other and make sure the flat faces are parallel then tighten the
5/16”
-
18 x 3/4” long hex
bolts and the elbow assembly screws enough to hold the elbows in place.
4.3. Measure the distance between the two larger round faces. The gap between the upper and lower
closure elbows should be the same but it is advisable to check both before cutting the tubes to fit
(FIG.15).
FIG. 15
Summary of Contents for Pathway Stair System
Page 12: ...12 FIG 12 FIG 13...