extronics iTAG, Operating Manual

Page: 9 / 20

9
Multicharger Usage Instructions
4.1
Before using the Multicharger
Please check for damage to the Multicharger and mains cable prior to use. Should
any damage be visible, do not use, and contact Extronics.
4.2
Mounting the Multicharger
For wall mounting, follow instructions in Section 5.1.
For table mounting, follow instruction in Section 5.2.
4.3
Charging iTAGs
Place the iTAG(s), up to 10 units, onto the Multicharger cradles as shown in Figure
4.3. It is not required to populate all charging slots, for safe operation, when the
Multicharger is ON.
Figure 4.3
4.4
Turning the Multicharger on or off
The Multicharger can be turned ON or OFF using its ON/OFF switch, Figure 3.1. The
Multicharger can be left turned on, even when no iTAGs are charging.