extronics iTAG, Operating Manual

Page: 6 / 20

6
Warning! Do not use the Multicharger when the room temperature is BELOW 0
o
C
(32
o
F) or ABOVE 45
o
C (113
o
F). At cold temperatures charging may take
longer.
Warning! Do not attempt to use the Multicharger with a step-up transformer, an
engine generator or DC power receptacle.
Warning! Do not
allow anything to cover or clog the Multicharger’s vents.
Warning! Never use gasoline, benzine, thinner, alcohol or the like to clean the
charger. Discoloration, deformation or cracks may result.
Warning! Only daisy chain Multichargers together. Do not daisy chain other
equipment to the Multicharger.
2.1.2 Wall mounting
Warning! Make sure to use the 4 screws for hanging the Multicharger on the wall.
Otherwise the Multicharger may fall and cause serious injury.
Warning! Always be sure that the Multicharger is unplugged and all the iTAGs are
removed from the Multicharger before performing wall mounting.
Warning! Follow the steps included in this manual and complete the whole
procedure at once. The Multicharger may fall and cause injury or damage
if you stop work part of the way through.
Warning! Check tightness of the screws on a regular basis. Otherwise the
Multicharger may fall because of loosened screws.
Warning! Carefully choose a stable wall for mounting the Multicharger. Make sure
there is no hindrance to mounting work or charging operation. The gross
weight of the Multicharger with 10 iTAGs is approximately 2.5Kg (5.5lbs).
Provide sufficient reinforcement for the wall if necessary.
2.1.3 Table mounting
Warning! Make sure that all 4 feet are adhered to the rear of the Multicharger.
Without the feet fitted, the Multicharger may slip off the table and cause
injury or damage.
Warning! Carefully choose a table for the Multicharger. Make sure there is no
hindrance to mounting work or charging operation. The gross weight of
the Multicharger with 10 iTAGs is approximately 2.5Kg (5.5lbs). Provide
sufficient reinforcement for the table if necessary.