extronics iTAG, Operating Manual

Page: 13 / 20

13
Follow the same steps for the next Multicharger in the chain. Note that the mains cable
doesn’t need to be fitted. Instead the previous daisy chain cable should be fitted into
the power in receptacle.
Repeat this process until all Multichargers are fitted. The final Multicharger in the chain
doesn’t need a daisy chain cable.
Finally,
plug the first Multicharger’s mains cable into the mains socket and turn each
Multicharger’s switch to the ON position. You are now ready to charge your tags –
Section 4.5.
5.2
Table Mounting
The Multicharger can be mounted onto a table top or daisy chained together whilst on
a table top. The supplementary bag contains 4 stick-on feet which can be stuck to the
Multicharger’s feet underneath the unit, Figure 5.2. The Multicharger’s feet mountings
may need a clean before applying the stick-on feet. These feet help to prevent the
Multicharger from slipping.
Figure 5.2
Ensure that the Multicharger or first Multicharger in the chain is sufficiently close to the
mains socket.
The Daisy Chain cable is not included with the Multicharger and needs to be ordered
separately. Contact Extronics and order part number X128426
.
Place the Multicharger(s) in the desired location(s) and either connect the daisy chain
cable from one Multicharger to another or connect each Multicharger’s mains cable to
an individual mains socket.
It is preferable to retain the cables using the ‘clip’ features.