Extron electronics XTP T USW 103, User Manual

Page: 24 / 46

XTP T USW 103 Switcher • Operation 16
EDID
`
To manage EDID on the XTP T USW 103, use the XTP System Configuration Software (see
EDID Minder
on page 35). The XTP T USW 103 can record and save EDID in a user
memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher
using the XTP System Configuration Software.
Reset Mode
Use the recessed
Reset
button on the rear panel of the switcher (see figure 12,
A
) to
restore factory-shipped firmware.
POWER
12V
2
1.0 A MAX
G
1
SIG LINK
LAN
AUDIO
RGB HDMI HDMI
CONTACT
Rx G G Tx
RS-232 IR
Rx Tx
RS-232
Tx Rx
3
1 2 3
R
OVER XTP REMOTE
INPUTS
XTP OUT
A
Figure 12. Rear Panel Reset Button
Reset Mode Summary
Mode Mode Activation Result Purpose and Notes
Factory
Reset
1
Hold down the recessed
Reset
button while applying power to the
device.
NOTE: After a mode 1 reset,
update the device with the
latest firmware version. DO
NOT operate the firmware
version that results from this
mode reset.
The device reverts to the factory
default firmware.
NOTE: If you do not want
to update the firmware or
perform a mode 1 reset by
mistake, cycle power to
the device to return to the
firmware version running prior
to the reset.
Use mode 1 to return
to factory firmware for
a single power cycle if
an incompatibility issue
arises.