IMPORTANT:
Refer to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
IMP
ORT
ANT
:
Refer to www
.extr
on.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
XTP T EU 202 and XTP T MK 202 • Setup Guide
This guide provides instructions for an experienced installer to install and connect the XTP T EU 202 or XTP T MK 202 into a junction box or
European cable channel system (referred to as a “Euro channel” in this guide). For junction boxes, the XTP T EU 202 fits into a two-gang European
junction box and the XTP T MK 202 fits into a two-gang MK junction box.
OVER XTP REMOTE
RS-232
RS-232
IR
Tx
Tx
POWER
12V
0.8A MAX
Tx
Rx
Rx
Rx
G
G
+ -
Rear
b cf
a
Extron
HDMI IN
XTP T MK 202
AUDIO IN
VGA IN
PWR HDCP HDMI VGA
CONFIG
d
j
Front
g
h
i
e
Throughput and Control Connections
Power Connection and Reset Button
Input Connections and LED Indicators
a
XTP connector
b
RS-232 and IR Over XTP connector
c
Remote RS-232 connector
d
USB connector
e
Reset button
f
DC power connector
g
HDMI connector
h
Analog audio input connector
i
15-pin HD connector
j
LED indicators
Figure 1.
XTP T MK 202 and XTP T EU 202 Rear (Left) and Front (Right) Panel Features (XTP T MK 202 Shown)
Installation
Planning
CAUTION:
Risk of personal injury.
Failure to check these items may
result in personal injury.
ATTENTION:
Failure to check the items listed below may result in
property damage.
Check that the installation meets the building, electrical, and safety codes.
Ensure there is enough space in the junction box or Euro channel for the
XTP transmitter, cables, and rear panel connectors when the XTP transmitter is
completely connected and mounted (see the
XTP T EU 202 and XTP T MK 202
User Guide
for more details).
NOTE:
The depth of the transmitters is 1.4 inches (35.42 mm).
Mounting and Cabling
For additional mounting details and considerations, see the
XTP T EU 202 and
XTP T MK 202 User Guide
at
www.extron.com
).
Step 1
—
Install the junction box or Euro channel
Install the appropriate junction box or Euro channel according to the requirements
of the manufacturer (refer to the manufacturer for more details). This may require
creating an opening in the mounting surface. If so, consider the following:
•
For accuracy, use a template or the mounting enclosure to mark cut guidelines.
•
To avoid making an opening too big, cut inside the marked guidelines.
Step 2
—
Install the mounting plate
For the XTP T EU 202, use four long mounting screws to attach the mounting plate
to the junction box (see figure 2).
For the XTP T MK 202, use two long mounting screws to attach the mounting plate
to the junction box (see figure 3).
NOTE:
For installation into a Euro channel, refer to the manufacturer of the
Euro channel for any additional installation requirements.
Figure 2.
XTP T EU 202 Installation Diagram
Figure 3.
XTP T MK 202 Installation Diagram
Wall Box
Mounting Plate
Extron
XTP T EU 202
Install the
mounting
plate.
Mount the
device.
2
4
Install the
mounting
plate.
Wall Box
Mounting Plate
Mount the
device.
2
4
Extron
XTP T MK 202
