XTP II CrossPoint Series • HTML Operation
79
Control Tab
Set and View Ties page
You can create ties on the
Set and View Ties
page. Access the
Set and View Ties
page by clicking the
Control
tab (see figure 38,
1
).
Figure 38.
User Control Ties page
The page consists of a matrix of input (rows) and output (columns) selection buttons of four
different colors:
•
Amber
buttons indicate
video and audio ties
.
•
Green
buttons indicate
video only ties
.
•
Red
buttons indicate
audio only ties
.
•
Gray
buttons indicate
no ties
.
The page displays only those inputs and outputs that are available on
installed
boards only.
Select and switch an input as follows:
1.
Click the
Video Only
,
Audio Only
, or
Video & Audio
button (
2
) to select video,
audio, or both for switching (audio follow or audio breakaway). Each mouse click on a
button toggles the other two buttons off.
2.
XTP II CrossPoint 6400 only
— If necessary, select the desired range of outputs to tie
by clicking either the
Ties 1-32
or
Ties 33-64
link on the left of
the
Set and View Ties
page.
3.
Move the mouse over the matrix of input and output selection
buttons (
3
). Click a button to create a pending tie (if a tie does
not exist) or pending untie (if a tie exists) of the input and output
associated with that button. A “
P
” (for pending) appears in the button.
NOTES:
•
If you lose track of the input and output associated with a specific button, let
the mouse rest over one of the tie buttons for a moment. A field pops up that
identifies the input and output for that button.
•
To tie an input to all outputs, click that input number.
4.
Click the
Take
button (
4
) to make the configuration changes or the
Cancel
button to
abandon the configuration changes.
