Extron Headquarters
+800.633.9876 Inside USA/Canada Only
Extron USA - West
Extron USA - East
+1.714.491.1500 +1.919.850.1000
+1.714.491.1517 FAX
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.299.1800
+971.4.299.1880 FAX
Extron Korea
+82.2.3444.1571
+82.2.3444.1575 FAX
Extron India
1800.3070.3777
(Inside India Only)
+91.80.3055.3777
+91.80.3055.3737 FAX
©
2016 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
2
Setting Up the VLP 202 and VLH 102 Microphones
1.
Set the channel using the rotary switch
1
. For the VLH 102, remove the battery cover to access this switch.
Settings:
A
= 2.3 MHz,
C
= 2.3 MHz (volume buttons disabled),
B
= 2.8 MHz,
D
= 2.8 MHz (volume button disabled).
NOTES:
•
Before first use, fully charge the battery (see the
Installing the VLC 202 Charging Station
section).
•
Each microphone must be on a different frequency. For example, if one microphone is set to channel
A
or
C
, then
the other microphone must be set to a different frequency, such as
B
or
D
(the handheld microphone has only
channels
A
and
B
).
•
Do not set more than one microphone to the same channel in a system.
2.
For pendant microphones only, apply the appropriate sticker (provided) at
2
to identify the microphone.
3.
Remove the battery cover
3
, insert the supplied rechargeable AA battery, and replace the
battery cover.
4.
For pendant microphones only, attach the lanyard to the microphone as follows:
a.
Press the lanyard into the guides on the sides of the lanyard lock
ã
.
b.
Press the top of the microphone clip to open it
ä
.
c.
Slide the lanyard lock upwards under the clip and release the clip
å
(see the illustration at right).
d.
Place the lanyard around neck. Holding the bottom of the lanyard, slide the
microphone and lock up so it is positioned approximately 4 inches (10.2 cm)
below the chin.
5.
Turn the microphone on by sliding the power switch
5
up. The LED lights green.
6.
Ensure that a direct line of sight exists from the microphone to the receiver (required
for proper operation). Do not block the IR transmitter window
6
.
7.
Speak in a normal tone of voice. Do not block the microphone port or grille opening
7
.
8.
Adjust the volume if necessary
8
(see the
VoiceLift Microphones (for PVS 407D)
Installation Guide
for details).
6
8
2
4
1
VLP 202 Pendant Microphone
5
3
7
Power
Indicator
LED
Top
Rear
VLH 102 Handheld Microphone
7
5
8
Power
Indicator
LED
1
3
6
å
Press to
Open Clip
Lanyard
Lock
Slide lock up
under clip, then
release clip.
ä
Push lanyard into
the guides on the
lanyard lock.
ã
68-2902-50 Rev. A
02 16
