Mounting the Enclosure
Mount the cable cubby enclosure in the table.
CAUTION:
The flanged edges of the top of the surface enclosure are sharp. These edges
are also soft and may be easily nicked or bent. Exercise caution when handling the
enclosure to prevent personal injury or damage to the enclosure.
ATTENTION :
Les extrémités à brides du haut de la surface du boîtier sont aiguisées. Ces
extrémités sont aussi lisses et peuvent facilement être coupées ou pliées. Soyez prudents
lorsque vous manipulez le boîtier afin d’éviter de l’endommager ou de vous blesser.
1
1
5
5
2
2
3
3
4
4
Figure 9.
Mounting the TLP 350CV Enclosure
1.
Remove the edge grommet protecting the edges of the trim ring (
5
) and the plastic film on
the finished surfaces.
ATTENTION:
•
Do not use isopropyl alcohol or other solvents to clean the Cable Cubby. Strong
solvents will ruin some finishes.
•
Ne pas utiliser de l’alcool isoproprylique ou d’autres solvants pour nettoyer le
Cable Cubby. Les solvants forts endommageront certaines finitions.
2.
Carefully lower the enclosure into the hole cut in the table (see
on
page 8). Ensure the trim ring (
5
) is flush with the top of the table.
3.
Under the table, attach the table clamps (
3
) to the pins on each side of the enclosure. It
may be necessary to loosen the wingnuts (
1
) and the Phillips head screws (
2
).
4.
Tighten the Phillips head screws until the clamp faces (
4
) are tightly secured against the
bottom of the table.
5.
To prevent the screws from becoming loose, secure the wingnuts against the table clamp
bodies.
TLP 350CV and TLE 350 • Mounting
14
Summary of Contents for TouchLink TLP 350CV
Page 6: ......
