Running Cables
Run all cables necessary to support the AC connector, the cables stored in the cubby, and all
planned AAP connectors. Run the cables below the table and through the hole that was cut in
the previous step (Cutting the Surface). Leave enough slack in the cables to connect or route
them before the cubby is installed in the table. Leave enough slack for the external power supply
and to connect AV cables and the cable for PoE and LAN to the TLP 350CV.
Installing Cable Retractors (Optional)
Extron cable retractors retract and store extended cables in Cable Cubby systems, preventing
them from tangling underneath the table. Retractor kits are available for several cable types. Up
to six retractors can be installed in the TLP 350CV enclosure (three at either end). They are not
provided with the TLP 350CV and must be purchased separately.
The buttons on the retractors must be placed at one end of the unit and must, therefore, be the
first or the last items added.
Secure the bolt
with the nut.
Secure the locking screw
on each retractor.
Do not overtighten.
Insert the bolt through the
retractor mounting hole on
the side of the Cable Cubby
and retractor assembly.
2
3
4
Insert retractors into the
touchpanel enclosure
from underneath.
1
Figure 5.
Installing Cable Retractors
To mount the retractors horizontally and for further information and installation instructions,
see the
Retractors User Guide
, which is available at
provides information about mounting the retractors at a 30° angle to satisfy ADA compliance
requirements.
TLP 350CV and TLE 350 • Mounting
10
Summary of Contents for TouchLink TLP 350CV
Page 6: ......
