Mounting the TLP Pro 1220TG, 1520TG, and 1720TG
Removing the Back and Base Covers
Some of these procedures require the back and base covers to be removed. You must remove
the back cover before you can remove the base cover.
1
1
2
2
Figure 23.
Remove the Back and Base Covers
1.
Use the provided Extron removal tool. There is one notch on each side of the back cover
(figure 23,
1
). Insert the tool into the notch to release the catch.
2.
Use the removal tool to remove the base cover. There are two notches at the back of the
base (
2
).
Desktop Mounting
The TLP Pro 1220TG, TLP Pro 1520TG, and TLP Pro 1720TG come assembled with stands that
allow the units to be placed on any suitable flat surface (for example a desk, table, or lectern).
Placement without a Mounting Kit
Figure 24 shows the base of the TLP Pro 1220TG, with the cover removed to indicate the
position of the mounting holes. The bases of the TLP Pro 1520 TG and TLP Pro 1720TG are
similar and the spacing of the mounting holes (figure 24,
1
) is identical.
1
1
Figure 24.
TLP Pro 1220TG Base, Showing Mounting Holes
1.
Mark the location of two mounting holes, 4.96” (126.0 mm) apart. This measurement is the
same for the TLP Pro 1220TG, TLP Pro 1520TG, and TLP Pro 1720TG.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Mounting
28
