Extron electronics TLP Pro 1025 Series, User Manual

Page: 43 / 48

Reset Modes
The touchpanels described in this guide have three reset modes that are initiated by pressing the
RESET
button. An additional (fourth) mode toggles between enabling and disabling the DHCP
client:
•
Use Factory Firmware (see below).
•
Reset All IP Settings (see page 34).
•
Reset to Factory Defaults (see page 34).
•
Enable or Disable the DHCP Client (see page 35)
The
RESET
button is found on the rear panel of the TLP Pro 525M, 725M, and 1025M series
(see figure 3
B
, on page 8) or the base of the TLP Pro 525T, 725T, or 1025T series (see
figure 4 ,
B
, on page 11).
Use Factory Firmware
This mode is used to boot up the unit with factory‑installed firmware for a single power cycle if a
firmware update fails or incompatibility issues arise with user‑loaded firmware.
Activation
To start the Use Factory Firmware reset mode and replace firmware:
1. Remove power from the touchpanel.
2. On the touchpanel, hold down the recessed
RESET
button (see figure 3 ,
B
) while
re‑applying power to the unit. When power is restored, the
Reset
LED lights. Hold the
RESET button for a further 2 seconds before releasing it. The touchpanel enters factory
firmware mode.
3.
Upload new firmware to the unit as desired (see Updating the Firmware on page 26).
NOTE: Do not continue to operate the touchpanel using the factory firmware version. If
you want to use the factory default firmware, you must upload that version again (see
Updating the Firmware ).
Result
The unit reverts to factory‑installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE:
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
TLP Pro 525, 725, and 1025 Series Touchpanels • Reference Material 33