SMP 111 • Introduction
5
Encoding and Output
The SMP 111 supports simultaneous streaming and recording, with one HDMI output. The
record and stream encoder settings can be configured as different bit rates, resolutions, and
frame rates. The HDMI output defaults to the record settings.
See
for a comparison of the two encoding types.
The video output can be scaled and its aspect ratio modified. The SMP 111 also outputs
high quality encoded HDMI video with embedded audio on a single output for display on
any HDMI display, supporting resolutions up to 1
920x1080
at
60 Hz
.
TCP/IP
Network
MARK
RECORD
USB STORAGE
Input
Outputs
HDMI/DVI
rear panel
local output
LAN
port
SMP 111
RCP 101
Deinter-
lacing,
scaling,
rasterizing
Frame rate
conversion
Record
encoding
Data /
recording
Control
signals
+12 V
power
Stream
encoding
Recording
files
Internal
storage
External USB drive
(front or rear port, or
RCP 101)
and /or
AV
Controls
panel
preview
Streamed
archive
output
= Recorded file upload (if set up)
= Optional streamed output
Automatic
2
upload of
recording
to a
network
drive
2
For automatic uploading, set a default
destination (Extron Entwine EMP system,
Kaltura system, Opencast system, or an
FTP, SFTP, or CIFS server location) to
which to publish recordings (
Recorded
Events
>
Publish Settings
).
HDMI/DVI
(with or
without analog
line level
analog audio)
Figure 2.
SMP 111 Block Diagram
File Storage
Internal storage is available for storing recordings to be uploaded to a file server. The
SMP 111 has a 32GB SD card internally, which is field upgradable to different storage
sizes (see
on page 106). You can view the total storage size in
the storage information table found on the
File
Management
embedded web page (see
Storage
Information
in the Help file) or in the storage information table found on the
Device
Status
embedded web page.
figure 2
