SMD 101 Reset Summary
The SMD 101 can be reset to default states using the rear panel reset button, the
Reset Device
page of the user interface, and SIS commands. Each reset affects different
configurations and local files, resetting some to factory condition and retaining others.
SMD 101 Reset Mode Summary
Mode Activation
Result
Purpose and Notes
Factory Firmwar
e
1
Press and hold the recessed
rear panel
Reset
button while
applying power to the unit.
The SMD 101 reverts to the factory
default firmware for a single power cycle.
If incompatibility issues arise with
user-loaded firmware, use mode 1
to revert to the factory default
firmware for a single power cycle.
All user files and settings are
maintained.
Reset Factory Defaults
3
Press and hold the
Reset
button for about 3 seconds until
the Reset LED blinks once, then
release and press
Reset
again
within 1 second*.
Mode 3:
•
Same as ZXXX SIS command.
•
Reset to defaults, but retains the IP
address and user files.
Mode 3 is useful for restoring Auto
video output rate if the display is
unable to support the currently
set rate.
Reset All IP Settings
4
Press and hold the
Reset
button for about 6 seconds until
the Power LED blinks twice
(once at 3 seconds, twice at
6 seconds). Then, release and
press
Reset
again within 1
second
*
.
Mode 4:
•
Sets port mapping back to factory
default.
•
Sets the IP address back to factory
default (192.168.254.254).
•
Sets the subnet mask address back
to the factory default (255.255.0.0).
•
Sets the gateway IP address to the
factory default (0.0.0.0).
•
Turns DHCP off.
•
The Reset LED on the rear panel
of the unit flashes four times in
succession.
Mode 4 is used to set
IP address information using ARP
and the MAC address.
Reset to Factory Defaults
5
Press and hold the
Reset
button for about 9 seconds
until the Power LED blinks three
times (once at 3 seconds, twice
at 6 seconds, three times at 9
seconds). Then, release and
press
Reset
again within 1
second
*
.
Mode 5:
Performs a complete reset to factory
defaults (except the firmware).
•
Does everything mode 4 does.
•
Clears port configurations.
•
Resets all IP options.
•
Clears all user settings.
•
Clears all files from the unit.
•
The Reset LED on the rear panel
of the unit flashes four times in
succession.
Mode 5 is useful when wanting to
start over with configuration and
uploading, and also to replace
events.
NOTES:
•
*
= For modes 3, 4, and 5, nothing happens if the momentary press does not occur within 1 second.
•
Although removable devices and network shares are accessible as part of the user file system, those
temporarily mounted file systems are not affected by reset operations. A mode 1, 3, 4, and 5 reset does
not un-mount removable devices. If required, those devices must be un-mounted manually.
SMD 101 • Reference Information
136
Summary of Contents for SMD 101
Page 2: ......
