b.
Remove a ceiling tile adjacent to the tile with the hole.
c.
Place both assembled V-rails on the cut ceiling tile and position them equally on
either side of the hole. The ends of the V-rails go over the ceiling grid.
d.
Position the C-ring assembly on the two V-rails so that the C-ring is centered over
the hole, as shown below.
V-rail
C-ring
Figure 3.
Positioning the C-ring assembly on the V-rails
e.
Secure the C-ring to the V-rails using two screws.
5.
Route the speaker wires
through the ceiling tile hole.
SF 3C LP and SF 3CT LP User Guide • Installation
6
Summary of Contents for SF 3C LP
Page 2: ......