9
Step 9: Cable the NBP 1200C and Other Devices in the System
1.
Run a network cable to the NBP 1200C.
2.
Connect the NBP to the network via the LAN/PoE port on the bottom panel of the NBP 1200C (shown in figure 11).
NBP 1200C
LAN/PoE
RESET
LAN/PoE
(Ethernet)
Connector and LEDs
Reset
LED and Button
MAC Address
Label
NBP 1200C Bottom Panel
MAC: 00-05-A6-
XX-XX-XX
S/N:
XXXXXXX
E
XXXXXX
00-05-A6-XX-XX-XX
Figure 11.
NBP 1200C Bottom Panel Features
Details of LAN/PoE port connection, LED behavior, protocol, addresses, and credentials are shown in figure 12.
LAN/PoE
RJ-45
Connector
NBP
Bottom Panel
LAN/PoE (Ethernet and
Power Over Ethernet)
Ethernet
NOTE:
MAC address information
(
00-05-A6-
XX
-
XX
-
XX
) is located
on the bottom panel, next to the
LAN port.
PC
Link LED:
Lights
green to indicate a
network connection.
Activity LED:
Blinks
amber to
indicate data
is being sent
or received.
TCP/IP
Network
Extron
Control
Processor
Connect to an Ethernet network.
This port must be configured.
Default protocol:
• NBP address: 192.168.254.
253
• Gateway IP address: 0.0.0.0
• Subnet mask: 255.255.255.0
• DNS address: 127.0.0.1
• DHCP: off
• Link speed and duplex level: autodetected
• Data rates: 10/100Base-T
Power over Ethernet (PoE):
The NBP receives power at this port.
Default login credentials:
• Username:
admin
• Initial password:
unit serial number
• Password after a “Reset to Factory
Defaults”:
extron
MAC: 00-05-A6-
XX-XX-XX
S/N:
XXXXXXX
E
XXXXXX
00-05-A6-XX-XX-XX
MAC: 00-05-A6-
XX-XX-XX
S/N:
XXXXXXX
E
XXXXXX
MAC
Address
Figure 12.
NBP 1200C LAN/PoE Port Details
IMPORTANT NOTES:
•
The factory configured password for this device has been set to the device serial number. Passwords are case
sensitive. Performing a Reset to Factory Defaults (see
password to
extron
.
•
DHCP is off by default.
3.
Cable devices to the control processor or HCR receiver (see the user guide for the appropriate device), and connect the
control processor or HCR receiver to the same network as the NBP.
4.
Connect power cords and power on the control processor or receiver and other devices.
ATTENTION:
•
Power over Ethernet (PoE) is
intended for indoor use only.
It is to be connected only
to networks or circuits that
are not routed to the outside
plant or building.
•
L’alimentation via Ethernet
(PoE) est destinée à une
utilisation en intérieur
uniquement. Elle doit être
connectée seulement à des
réseaux ou des circuits qui ne
sont pas routés au réseau ou
au bâtiment extérieur.