8
NBP 1200C • Setup Guide (Continued)
Step 7: Install Retractors
Retractors can be installed in a vertical, angular, or horizontal orientation. No adjustment of the enclosure screws is needed if
the retractors are mounted vertically. To mount at an angle or horizontally, adjust the enclosure screws as shown below. When
the Retractors are mounted horizontally, the retractor mechanism must be secured to the underside of the table (see the
Cable
Retractor Setup Guide
, available at
).
To secure the Retractors in the retractor bracket, follow the instructions in figure 9.
e
ON
OFF
PC
LAP
TO
P
MU
TE
ME
DIA
PLA
YER
HD
MI
1
HDM
I 2
Insert the pin through the
Retractor mounting hole on
the side of the Cable Cubby
and Retractor assembly.
Secure the clip
on the pin.
Insert Retractors
into the Retractor
bracket.
Secure the locking screw
on each Retractor. Do not
overtighten.
2
3
1
4
Figure 9.
Installing Retractors
Step 8: Install Cables in the Cable Cubby
e
ON
OFF
PC
LAPT
OP
MUTE
ME
DIA
PL
AYE
R
HDM
I 1
HDM
I 2
For cable pass-through applications,
allow at least 36 inches (0.9 m) of
cable loop for each cable.
Using zip ties, secure cables to the holes
on the bottom of the Cable Cubby.
1
2
3
NOTE:
Ensure there is no tension
on the power cable.
Connect cables to the AV system
and connect the AC power cord
to any installed power module.
Figure 10.
Routing and Connecting AV Cables
Horizontal Mounting
Remove two enclosure screws
(one on each side) from this position.
Then mount the Retractors as shown at left.
Cable Release
Assembly
See the
Cable Retractor Setup Guide
for
additional steps.
Angular Mounting
Remove the two enclosure screws, as shown
above, and then follow this step:
Move the cable release assembly upward until
the angular mounting hole is visible. Reinstall
the enclosure screws in this hole (both sides).
CAUTION:
Risk of Electric Shock
. This
equipment must be grounded.
ATTENTION :
Risque de choc électrique.
Cet équipement doit être fixé au sol.