2
NBP 1200C • Setup Guide (Continued)
Americans with Disabilities Act (ADA) compliance
When planning where to install the NBP button panels, you may need to consider factors affecting accessibility of the button
panels such as height from the floor, distance from obstructions, and how far a user must reach to press the buttons. For
guidelines, see sections 307 (“Protruding Objects”) and 308 (“Reach Ranges”) of the
2010 ADA Standards for Accessible Design
available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf
Included parts
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
2
2
2
2
2
2
2
2
2
5
5
5
5
5
5
5
5
5
5
1
1
1
1
1
e
21-525
-01LF
e
ON
OFF
PC
LAPTOP
MUTE
MEDIA PLA
YER
HDMI 1
HDMI 2
Figure 1.
NBP 1200C Included Parts
Item
Qty
Item
Qty
Item
Qty
1
NBP 1200C
1
6
Retractor pin and clip
1
9
Hole plugs
6 (3/8")
2 (1/4")
2
Connectivity bracket
1*
7
6 pan-head mounting screws
and star washers
8
3
AAP frame plate
1
Extron removal tool (not shown)
1
4
Cable grommet plate
1
8
4-40 module screws
8
Extron Tweeker (small
screwdriver) (not shown)
1
5
Retractor bracket
1
Blank buttons (not shown)
1
NOTE:
*A single connectivity bracket is provided. It can be used with either the AAP frame plate or the cable grommet plate.
Step 2: Prepare the Installation Site, Cut the Table or Furniture
ATTENTION:
•
Installation and service must be performed by authorized personnel only.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé uniquement.
•
If the NBP will be installed into fine furniture, it is best to hire a licensed, bonded craftsperson to cut the access hole and
perform the physical installation so the surface will not be damaged.
•
S’il est prévu d’installer le NBP dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et qualifié pour
couper le trou d’accès et réaliser l’installation de telle façon que la surface ne soit pas endommagée.
•
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s’appliquent au site de l’installation.
Site preparation
To prepare the site:
1.
Decide on the method for cutting a hole in the table (see the next page).
2.
Obtain the cut-out template. Verify that you have the correct cut-out template and dimensions (see the next page).
3.
Protect the surface prior to and during cutting so the surface is not damaged.
