Extron electronics MTPX 1616, User Manual

Page: 55 / 124

3-29
MTPX Twisted Pair Matrix Switchers • Operation
PRELIMINAR
Y
Example 8: Viewing and adjusting an input audio level
N
This procedure can only be performed if the audio/RS-232 wire pair of the input
is defined as audio (see “Defining the Audio/RS-232 wire pair“ on page 3-38.
N Because of the different gain and attenuation display schemes, the input audio
levels that result from the following example are shown twice: as displayed on a
16-output button switcher and on a 32-output button switcher. The 16-button
displays show the actions that led up to the display. For simplicity, the figures
showing 32-button displays show the gain or attenuation display only, not the
actions that led up to it.
The following example shows an audio level being viewed and adjusted. The steps
show the front panel indications that result from your actions.
The output LEDs display the audio gain and attenuation by blinking and light
subsequent LEDs. For 16-button switchers, each output LED indicates 1 dB when
blinking and 2 dB when lit steadily. See the table on page 3-27. For 32-button
switchers, each output LED indicates 1 dB. See the table on page 3-28. The
Esc > LED lights to indicate gain and the View < LED lights to indicate attenuation.
1 . Press and release the Esc button (figure 3-43).
ENTER PRESET VIEW ESC
CONTROL
Press the Esc button to clear all selections.
The LED
blinks once.
Figure 3-43 — Clear all selections
2 . Press and hold the Audio button for approximately 2 seconds until the
Audio LED blinks (figure 3-44).
VIDEO AUDIO AUDIO
I/O
The LED blinks to
indicate Audio mode.
Release the button.
Press and hold
the Audio button.
2 seconds
Figure 3-44 — Select Audio mode