MP 101 Series • MP 101 D
13
3.
Set the Mic Gain potentiometer by saying a few words into the microphone and
adjusting for the maximum sound level that is free of distortion.
NOTE:
If there is a remote control connection, unplug it while adjusting the Mic
Gain potentiometer. Replace the remote control when finished.
If there is minimal distortion, but greater volume is required, turn the Mic Gain
potentiometer clockwise (towards the 75 dB mark) to increase the volume, but not past
the point where distortion occurs.
Mounting the MP 101 D
The MP 101 D provides the same features as the other MP 101 models in a convenient,
Decorator-style wallplate.
NOTE:
Before mounting, the MP 101 D should be tested to verify that its connections
and settings are correct.
To mount the MP 101 D into a Decorator-style faceplate, do the following:
1.
Secure all cables and connections onto the MP 101 D.
2.
If it was not done previously, adjust the MP 101 D from its rear panel (see
on the previous page for detailed instructions).
3.
Place the MP 101 D through the opening in the wall or furniture and into the wall box.
Take care not to damage the output cables, which fit behind the preamplifier at the back
of the wall box.
4.
Attach the Decorator-style wallplate to the MP 101 D, as shown below.
Wall opening
is flush with
edge of box.
Wall Box
Decorator Style
Faceplate
Extron
MP 101 D
Mic to Line
Preamplifier
MIC
IN
ACT
IVE
MU
TE
Figure 10.
Mounting the MP 101 D
5.
Pretest the MP 101 D before performing the final mount in step 6.
6.
Perform the final mount by attaching the cabled MP 101 D and Decorator-style
faceplate into a wall. For detailed installation information, refer to the installation guide
shipped with the Decorator-style faceplate.
