MLC 104 IP Plus Series • SIS
™
Programming and Control
106
Command/Response Table for Special Function SIS Commands (continued)
Command
ASCII
Command
(host to MLC)
Response
(MLC to host)
X?
values
and additional descriptions
Front panel button LED control
24
X?
*
Y?
*51#
Lmp
Y?
*
X?]
This command controls which
LED(s) turn on or off or blink in a
specific button.
X?
is the LED state,
Y?
is which projector power,
input, or other button to control.
See the list of values at left or the
diagrams on pages
0
= all LEDs are off
1
= green LED is on
2
= red LED is on
3
= green & red LEDs are on
(button glows amber)
4
= slowly blinking green
5
= slowly blinking red
6
= slowly blinking amber
7
= fast blinking green
8
= fast blinking red
9
= fast blinking amber
1
= power on button
2
= power off button
9
= input button 1
10
= input button 2
11
= input button 3
12
= input button 4
To control the LEDs for
CM-3BLB or CM-9BLB
buttons, see the button
memory block map for
control modules (page 105).
X?
Y?
values
values
Query button LED control status
Y?
*51#
X?]
See the variables for the
command shown above.
NOTE:
) to set a button for an LED combination other than those
listed above for
X?
, the MLC responds with a zero (
0
). For example, if a button is set for its green LED to
blink slowly and its red LED to blink fast, the MLC sends
0
in response to the
Y?
*51#
command.
Miscellaneous settings
Enable switcher slaving
X?
*41#
Slave*
X?]
For
X?
,
0
= disable control of a slaved
Extron MLS switcher,
1
= enable (default) MLS slaved
switcher control.
Volume knob mode
24
X?
*46#
VolMode*
X?]
For
X?
,
0
= discrete volume values,
1
= continuous increment/
decrement.
Max. volume range
24
X?
*47#
VolMax*
X?]
For maximum volume,
X?
is
1
to
100
.
100
= default.
NOTE:
Maximum volume range cannot be changed while an MLS switcher is detected at the MLS switcher port
on the MLC.
NOTE:
When the maximum volume is changed, the volume level and the volume limit during display power-up
(
11#
) are set to 25% of the new maximum volume setting.
Volume encoder scale
24
X?
*49#
EncScale*
X?]
For
X?
:
0
= no scaling (default),
1
= decrease encoder speed
by 2,
2
= decrease encoder speed
by 3,
...,
255
= decrease encoder speed
by 256.
NOTE:
Use this command to slow down how fast the volume changes while
you turn the Volume knob or press a volume button on the remote
control. The more the encoder speed decreases, the more turns or
button presses it takes to change the volume by the same amount.
Summary of Contents for MLC 104 IP Plus Series
Page 6: ......