Standalone MediaPort 200
Audio Line Outputs
Analog Line Output
The Analog Line output connects the MediaPort to a local sound reinforcement system and
can be configured to as stereo or dual mono output via PCS (see
page 57). Only the line input program audio sources and the far end USB
communications audio are mixed to the line output.
NOTE:
Mic/Line Input audio is not sent to the analog Line output
USB Line Output
The USB Line Output carries all program and speech audio from the near end through the
USB port to the PC to be sent to the far end.
Ref and Aux Outputs
The following outputs are on a shared connector on the MediaPort 200 rear panel:
•
The Ref output is designed to be used in conjunction with an external DSP with AEC.
However, the Ref output can be used to send USB communications audio to a separate
sound system.
•
The Aux output contains only the Mic/Line input signal from the MediaPort 200. This
output allows the Mic/Line input signal to be sent to a voicelift system if local speech
reinforcement is needed. Alternatively, the Aux output can send the Mic/Line input signal
to a hardware video codec if one is in use.
MediaPort 200 • Standalone Application Setup
85
