Extron electronics HDMI 201 A D Tx, User Manual

Page: 16 / 28

HDMI 201 Tx/Rx • Installation and Operation
Installation and Operation, cont’d
2-16
HDMI 201 Tx/Rx • Installation and Operation
2-17
HDMI 201 Tx Rear Panel
POWER
12V
0.4A MAX
RS-232
PASS THRU
Tx Rx
1 2
HDMI INPUT
HDMI 201 Tx
PO
WER
12V 0.4A MAX
DO NOT
CONNECT
TO LAN
1
2
O
U
T
P
U
T
S
HDMI 201 A D Tx
L
A
UDIO
OUTPUT
R
4
6
HDMI 201 A D Tx Rear Panel
5
4 1 2 5
Figure 2-13 — HDMI 201 Tx rear panel connectors
N The RS-232 connector can also transmit one-way
modulated infrared (IR) signals. See "Modulated IR
pass through" on page 2-32.
c
Input Audio — Plug an unbalanced stereo audio input into this
pair, left and right, of female RCA connectors (figure 2-14).
Sleeve (Gnd )
Tip (+)
Sleeve ( )
Right Channel
(Red Jacket)
Left Channel
(White Jacket)
Tip (Signal)
Figure 2-14 — RCA connector wiring
d
DC power input connector — Plug the included external
12 VDC power supply into either this 2-pole connector or the
power input connector on the receiver (item
g
on page 2-20).
See "Power supply wiring," on page 2-25, to wire the connector.
e
Transmitter output connector —
Connect one end of two
separate TP cables to these RJ-45 female connectors on the
transmitter.
C Do not connect these devices to a computer data or
telecommunications network.
N Extron recommends 28AWG to 24AWG TP cable for the
RJ-45 connectors.
Connect the free ends of the same TP cables from the transmitter
to the receiver’s Input RJ-45 female connectors (item
h
on
page 2-20).
N Connect transmitter output 1 to receiver input 1.
Connect transmitter output 2 to receiver input 2.
N If necessary, test for proper cable connection (output 1 to
input 1, output 2 to input 2) as follows:
1 . Plug both TP cables into the powered unit.
2 . Momentarily connect either of the cables on the
opposite end into the unpowered unit‘s “2” connector.
If the unpowered unit’s Power LED is lit , the
connection is correct.
If the unpowered unit’s Power LED is not lit ,
unplug the connector on the unpowered end and
connect the other cable to the “2” connector.
See "TP cable termination," on page 2-22, to properly wire
the RJ-45 connectors.