Extron electronics DXP HD 4K Series, Setup Manual

Page: 56 / 60

50 DXP HD 4K Series • Remote Control
Accessing the Web Page
The embedded DXP HD 4K Web page enables you to monitor
and adjust certain settings of the DXP through its Ethernet port,
connected via a LAN or WAN and using a Web browser such as
Microsoft
®
Internet Explorer
®
. This factory-installed Web page is
always available and cannot be erased or overwritten.
NOTE: If your Ethernet connection to the DXP is unstable,
try turning off the proxy server in your Web browser. To do
this in Microsoft Internet Explorer, click
Tools > Internet
Options > Connections > LAN Settings , clear the Use a
proxy server... checkbox, then click OK .
To access the HTML page:
1. In the
Address
field of your Web browser, enter the IP
address of your unit. The default address for most Extron
products is 192.168.254.254. You can change this address
using SIS commands, the PCS configuration software, and the
DXP HD 4K Series Web page (see the
DXP 4K HD User Guide ,
available at
www.extron.com
, for instructions).
2. Press the <Enter> key. The DXP checks to see if the Web page
is password protected.
•
If the unit is not password protected, the Web page opens.
•
If the unit is password protected, the
Authentication
Required dialog box opens.
3. If an administrator or user password is required, enter the
user name (
admin , by default) in the User Name field and the
password in the Password field. Click Log In .
The DXP HD 4K Web page contains the following panels:
• Input Status — Displays the signal type and status of each
input.
• Output Status — Displays the signal and display type of each
output.
• Communication Settings — Displays the IP and gateway
addresses and the subnet mask of the DXP, as well as DHCP
status and MAC (hardware) address. To edit these settings
(except the MAC address), click the
Edit button to access
editable fields.
• Device Info — Displays information about the DXP model,
including the model type, part number, firmware version, and so
on (see
figure 30 , 1 , on the next page).
•
To assign a new name to the device, click the Edit button
in this panel.
•
To update the firmware, click the Update button (
2
).